================================================================
 PRINT JOB SHEET - UNIDEN SDS200 DISPLAY GLARE SHROUD v1.0
================================================================

PARTS
  1. sds200_fit_gauge_v1.0.stl    Qty 1   Print FIRST (fit check)
  2. sds200_glare_shroud_v1.0.stl Qty 1   Production part

  NOTE: Default STLs use ESTIMATED display dimensions
  (opening 76 x 58 mm, flange 6 mm). If the requester supplied
  measurements, regenerate from SOURCE/sds200_glare_shroud.scad
  before printing.

MATERIAL
  Preferred : ASA, matte black
  Alternate : ABS, black  |  PETG, matte black (minimum)
  DO NOT USE: PLA / PLA+ (softens in hot vehicle interiors)

ENVELOPE / ESTIMATES (default dimensions)
  Shroud    : ~100 x 70 x 45 mm, ~20 cm3, ~25-30 g
  Fit gauge : ~88 x 70 x 2 mm,   ~3.5 cm3, ~5 g

ORIENTATION
  Flange flat on build plate, exactly as modelled (Z up = out
  of radio face). No rotation needed. NO SUPPORTS.

SLICER SETTINGS (0.4 mm nozzle)
  Layer height      : 0.20 mm
  Perimeters/walls  : 6 (walls are 2.4 mm - solid walls)
  Top/bottom layers : 5 / 5
  Infill            : 25% gyroid
  Brim              : 5 mm (ASA/ABS)
  Supports          : None
  Seam              : Aligned / rear (far-wall outer face)
  Cooling           : ASA/ABS 0-20%, PETG 40-60%
  Enclosure         : Required for ASA/ABS

TEMPERATURES (typical - follow filament maker's data)
  ASA  : nozzle 240-260 C, bed 90-110 C
  ABS  : nozzle 230-250 C, bed 95-110 C
  PETG : nozzle 230-250 C, bed 70-85 C

QUALITY CHECKS
  [ ] Flange flat within ~0.3 mm (no warp at corners)
  [ ] Opening within +/-0.3 mm of target (measure with calipers)
  [ ] No layer splits at wall-to-flange joints
  [ ] Wall tops clean; no stringing inside the hood
  [ ] Matte finish, no gloss on inner faces

POST-PROCESSING
  - Remove brim; deburr edges lightly (no sharp corners)
  - Optional: light scuff of inner faces with 400-grit for a
    flatter matte
  - Optional: line inner walls with black flocking paper
  - Do NOT paint the flange bonding face

DELIVERABLE
  Fit gauge + finished shroud, packed so the tall wall cannot
  be crushed.

Full details: SDS200_Glare_Shroud_Instructions.pdf
================================================================
